- 6 -
Motor unit assembly
1.
Loosen the stopper screw (g), tilt head adjustment bolt (h), washer (i) and fixing nut (j) from the motor
connector. (fig. 6)
2.
Slide the motor unit into the slot of the motor connector. Align the holes on the connector and the motor
unit, insert the tilt head adjustment bolt, washer and fixing nut, and then use a wrench to fasten them firmly.
Tighten back the stopper screw. (fig. 7)
3.
Loosen the cable clamp screw (k) on the motor connector. Place the power cord (l) through the cable clamp
(m). Then fix the screw back. (fig. 8)
Note: The length of the power cord between the motor unit and the cable clamp cannot be too short. Make
sure there is enough space in between so that the fan head can operate smoothly for swing function.
fig.6 fig.7
fig.8
Make sure the top point of
the bolt is correctly aligned
with the groove in the hole.
Summary of Contents for CFH-212922.1
Page 1: ......