emerio AF-124772, Instructions Manual

Page: 10 / 70

- 9 -
Problem Possible cause Solution
The device does not work. The
displays on the control panel does
not switch on.
The door is not closed properly. Close the door.
The mains plug is not inserted
correctly in the plug socket. Push the mains plug into the plug
socket as far as it will go.
The plug socket is defective. Try another plug socket.
No mains voltage is predent. Check the fuse of the electical
distributor (fuse box).
The overheating protection has
been triggered. Pull the
m
ains plug out of the plu g
socket and allow the device to cool
down completely. Then try again.
The fuse in the electical
distributor (fuse box) is triggered.
Too many devices connected to
the same circuit. Reduce the number of devices in
the circuit.
The food has not been cooked
evenly.
Different items of food with
different cooking times have been
prepared at the same time. Place food with a longer cooking
time in the device first, and then
add ingredients with a shorter
cooking time later.
Items of food which require
different cooking temperatures
have been prepared at the same
time. Prepare items of food with
defferent cooking temperatures
one after another.
The set cooking time was too short
or the temperature was too low. Increase the cooking time or
temperature.
The rotating basket or baking rack
is overfilled. Reduce the amount of food.
The items of food are piled on top
of one after another. Spread the food and mix it around
from time to time.
The food is slightly burnt.
The selected temperature is too
high or the cooking time is too
long. Reduce the temperature or
cooking time.
Chips made from fresh potatoes
are not crispy.
The potatoes contain too much
water. Cut the potatoes into narrow
pieces. Dab the potato pieces dry
with some kitchen towel and then
trickle a little cooking oil over
them.
During use, an unpleasant smell
or smoke is detected.
The device is dirty. Follow the instructions in the
section “cleaning and
maintenance”.
The device is being used for the
first time. A smell often develops wh
e
n new
devices are first used. The smell
should disappear once the device
has been used several times.
Too much oil or grease. Remove excessive oil or grease.
Error messages E1 or E2
The sensor is defective. Contact the customer service
department.
TECHNICAL DATA
Operating voltage: 220-240V~ 50/60Hz
Power: 1800W