EMC2 DS-F20P-10GigE, Installation And Replacement Manual

Page: 10 / 16

10
DS-F20P-10GigE Installation and Replacement Guide
Installing the switch in a standard-depth cabinet
Installing the adjustable rails
The front edge of each rail is stamped L or R for left and right sides,
when they face the cabinet front.
1. From the front of the cabinet, insert the alignment pin on the right
mounting rail assembly into the middle hole of the selected 1U
space on a rear channel.
Figure 3 shows the correct channel holes
for the alignment pins.
Figure 3 Aligning pins in a 1U section on the cabinet’s rear rails
2. Pull the adjustable rail forward to the inner side of the front
channel (the surface facing the rear of the cabinet), and align the
three holes on the rail with those in the channel (
Figure 4 ).
3. Secure the rail to the front channel using one of the provided
screws at the top hole of the rail. Leave the screw slightly loose to
allow for adjustment after you install the enclosure (
Figure 4 ).
4. Repeat steps 2 and 3 on the left side, with the left rail ( Figure 4 ).
5. From the rear of the cabinet, use two of the provided screws to
secure each rail to the rear channel. Tighten the screws.
1U
Alignment Pin
Here
EMC2922