EMC VPLEX, Installation And Setup Manual

Page: 37 / 94

Setting up a VPLEX Local implementation 37
Setting up VPLEX
where <hostname> is a name for the management server, such as Cluster1 . (The
cluster is assigned a Cluster ID of 1 automatically.) This name replaces the default
name (
service ) in the shell prompt the next time you open a PuTTY session to the
management server.
18. From the shell prompt, type the following command, to verify connectivy to
director 1-A:
ping 128.221.252.35 -c 5
Note that -c 5 sets the number of pings to 5.
19. Repeat step 18 once for each director in the cluster, substituting the applicable
address shown in Figure 25 on page 37 .
Figure 25
Director A-side addresses
20. Type the following command to connect to the VPlexcli:
vplexcli
Log in with username service and password Mi@Dim7T .
21. Type the following to configure the IP address of the management server’s public
Ethernet port:
management-server set-ip -i <IP_address> : <netmask> -g <gateway> eth3
22. The next step depends on how you want to proceed:
• If you are leaving the laptop connected to the management server, go to “Task
2: Launch the EZ-Setup Wizard” on page 40 .
• If you want to connect over the network, proceed to step 23 .
23. If you want to connect over the customer network to perform the remaining setup
tasks, type the following command at the VPlexcli prompt, and again at the Linux
shell prompt:
exit
128.221.252.36
128.221.252.35
Engine 1:
Director 1-B
Director 1-A
128.221.252.38
128.221.252.37
Engine 2:
Director 2-B
Director 2-A
128.221.252.40
128.221.252.39
Engine 3:
Director 3-B
Director 3-A
128.221.252.42
128.221.252.41
Engine 4:
Director 4-B
Director 4-A
Single-engine
cl u ster
D u al-engine
cl u ster
Q u ad-engine
cl u ster