NOTICE
DO NOT REMOVE an SP assembly while the "Unsafe to remove SP" LED shown below is lit.
Refer to
while performing the procedure that follows.
Procedure
1. Disconnect the network and all other cables from the back of the SP assembly; label
the cables with the port numbers from which you removed them.
NOTICE
Do not remove any cables from the other SP assembly.
CAUTION
The SP assembly comes completely out of the enclosure. In addition to holding the
latches, be prepared to support the SP assembly to avoid dropping it.
2. Squeeze the orange levers on the latches on the sides of the SP assembly to release
the latches, and then pull the latches outward.
3. Pull out the latches until they are fully extended and the SP assembly is released from
the enclosure.
4. Use the latches to slide the SP assembly about half-way out of the enclosure.
5. Use both hands to support the SP assembly and pull it fully out of the enclosure.
6. Place the SP assembly on a clean, flat static-free work surface.
Figure 3 Removing an SP assembly
CL5231
2
1
7. Wait for all LED indicators on the removed SP to turn OFF before continuing.
This will occur in about 60 seconds.
Replacing an input/output module in a disk processor enclosure
Removing an SP assembly
7
