5
5-50
Configuring the Director
Figure 5-27
Configure Threshold Alerts Window — Activate Alert
Modifying Alerts
Use the following steps to modify an existing threshold alert
configuration.
1. Click Configure on the Product Manager menu bar and select
Threshold Alerts
on the drop-down menu.
This displays the Configure Threshold Alerts window (Figure
5-22 on page 5-45).
2. Select the alert that you want to modify by clicking the alert
information in the table.
3. If the alert is active, select Deactivate; then select the alert
information in the table again.
4. Select Modify.
If the alert is active, an error message displays prompting you deactivate
the alert.
5. An initial Modify Threshold window appears, where you can
change the threshold type.
Select a threshold type from the drop-down list.
Summary of Contents for Connectrix ED-64M
