EMC Connectrix ED-64M, User Manual

Page: 170 / 476

5
5-42
Connectrix ED-64M User Guide
Configuring the Director
Configuring the Date and Time
Use the procedures in this section to display and change the date and
time set on the director. You must set the current date and time on the
director so the various logs display the correct time stamps.
1. Click Configure on the Product Manager menu bar and select
Date/Time on the drop-down menu.
This displays the Configure Date and Time dialog box (Figure
5-21).
Figure 5-21
Configure Date and Time Dialog Box
If the Periodic Date/Time Synchronization checkbox is checked,
the Connectrix service processor periodically synchronizes the
director time to the Connectrix service processor, and the time is
automatically corrected for daylight savings time.
If the Periodic Date/Time Synchronization checkbox is not
checked, you can set the Connectrix service processor date and
time manually.
If the director’s Management Style is FICON, an error will result
if both Periodic Synchronization and Director Clock Alert Mode
are enabled.
To disable periodic date/time synchronization, click the checkbox
to remove the check mark, then click Activate. To reenable
periodic date/time synchronization, click the checkbox to display
the checkbox, then click Activate.
Click Activate to synchronize the date and time at the next update
period. Click Sync Now to synchronize the date and time immediately.