EMC Connectrix EC-1100 System, User Manual

Page: 156 / 216

B
B-2
Connectrix EC-1100 System User Guide
Setting the ED-1032 Network Addresses
IP Address
CAUTION
!
Before changing any addresses on the ED-1032, be sure to record
the default address that appears in the first of each of these steps.
Keep the default addresses in a safe place in case you ever have to
return to the default address.
Set the ED-1032 IP address at the operator panel (shown in
Figure B-1). Use the address obtained from the network
administrator.
Figure B-1
ED-1032 Operator Panel
Only one IP address is required even though the ED-1032 contains two
Control Processor (CTP) cards and two LAN connections.
1. Press Advance until the IP address appears on the status display
as shown below:
Refer to IP Address Assignment on page E-2 for an explanation of
IP address conventions.
Power
IML
Advance Entry Detail Clear
System
Error
Control
Buttons
Status
Display
IP ADDRESS
10.x.5.n