4
EMC Departmental Switch DS-24M2 Installation Guide
Switch Mounting Kit Parts List
Tools Required for Installation
You will need the following tools to complete the installation of the
rails and switch(es). These tools are not available in this kit.
◆
# 2 Phillips head screwdriver
◆
A tape measure
#10 washers ball studs
1 washer and 1 ball stud per rail to hold
bezel (2)
39U bezel only
Latch brackets and keyplate spacers
2 each to secure 1U bezel in 40U
cabinets
Ten (10) Phillips pan-head screws (#10 32x5/8) with split lock and flat
washers (SEMS)
Attaches the rail mounting hardware in
a 40U cabinet and a 39U cabinet
(round-hole channel only)
Four (4) Phillips flat-head screws (#8 32x3/8)
Attaches the combined front and rear
rails.
Eight (8) Phillips flat-head screws (#10 32x5/8) and
Eight (8) square-hole washers
Attaches the rail mounting hardware in
a 39U cabinet (square-hole channel
only)
Four (4) Phillips flat-head securing screws (#8x32)
Attaches the switch to the combined
front and rear rails.
A #10 Torx® screwdriver
Removes and installs the Torx screws
on the switch.
1U low-profile or standard-profile bezel (front rack panel)
1 per switch
Component
Use