EMC CLARiiON CX700, Hardware Reference Manual

Page: 72 / 114

3-16 CX700 Hardware Reference
Servicing a CX700 SPE
2. Release the latches on either side of the storage processor module
as indicated by the icons on the SP panel . Note that
• SP A and SP B are reversed, so the latches will turn in opposite
directions to release.
• Unlike captive screws (which they resemble), the latches need
only 1/4 turn to release or secure.
3. Use the handles to pull the storage processor module from its slot.
See Figure 3-11.
Figure 3-11 Removing a Storage Processor
4. Place the storage processor on a static-free surface.
Installing a Replacement Storage Processor
1. Remove the new SP from its static-free packaging.
2. Be sure the latches on either side of the SP module are in the open
position.
3. Align the storage processor module with the guides on the side of
the enclosure. Gently slide the SP into the enclosure, as shown in
Figure 3-12. Be sure the module is completely seated in the CX700
midplane.
The SP Power light will turn on.
EMC2397