- 10 -
Laminate with backing paper:
• Open the lamination roller by pressing the button OPEN key and put in the laminate as shown in the picture.
Push an empty roller core onto the roll-up axle R3 so that the protective liner/backing paper can be rolled up.
• After you have attached the laminate to the roll-down axle R4, separate the backing paper and use tape to fas
-
ten it to the cardboard core on the roll-up axle R3. Ensure that the protective liner has been fastened uniformly
without cross creases. Pull the laminate between the rollers and stick it onto the upper roller with tape. When
doing this ensure that the foil is spread out evenly across the whole width. If there are creases or folds, repeat
the steps until the material is perfectly positioned.
• By adjusting the coupling of the roll-up axles the pull of the R3 axle can be stopped. Only a small amount of
power is required to roll up the liner. Therefore, do not select a very high value.
• The required breaking power is normally low unless the protective liner has much more power than the vinyl. In
this case the tensile force has to be increased accordingly.
• Use the button MANUAL
È
/
Ç
to put the upper roller about 1 cm apart the lower roller. The laminate might
come loosen during this time and no longer stick to the roller properly. Correct the film again.
• Put the print to be laminated between the laminating rollers as shown in the picture. Use
Ç
and
È
to adjust the
rollers completely to position 0 or use „FILM“ or „FOAM“ to shut the rollers or use foot switch at back side.
• Release the film that you have fixed with tape to the upper roller and start running the machine.
Laminating with backing paper:
LINER-AUFROLLVORRICHTUNG
DRUCKMEDIUM
GUMMIWALZEN
LAMINAT
FERTIGES PRODUKT
Summary of Contents for EASYLAM 140 C
Page 1: ...Operating instructions Laminator Version 1 0 140 C...
Page 15: ...15...