Page | 56
NAND write: device 0 offset 0x80000, size 0x39590
234896 bytes written: OK
reading uImage
3224184 bytes read
HW ECC BCH8 Selected
NAND write: device 0 offset 0x280000, size 0x313278
3224184 bytes written: OK
reading ubi.img
14811136 bytes read
SW ECC selected
NAND write: device 0 offset 0x780000, size 0xe20000
Skip bad block 0x00ce0000
14811136 bytes written: OK
A Flashing LED on the board indicates that the update has been finished;
please remove TF and reboot the board.
4.
U-boot configuration
By default the system image has been set for 4.3” LCD. You can change the
settings in UBOOT according to the detailed instructions contained in the
next section.
6.7
Instructions
6.7.1
Selecting the Display Mode
The system supports a wide range of display modes. Users can change the
display mode by modifying the U-Boot configuration parameters.
How to enter the u-boot command mode:
Power on the board and press any key on PC’s keyboard to enter u-boot
when you see “Hit any key to stop autoboot” in your terminal window.
U-Boot SPL 2011.09-svn55 (Nov 20 2012 - 10:37:42)
Texas Instruments Revision detection unimplemented
Booting from MMC...
OMAP SD/MMC: 0
reading u-boot.img
reading u-boot.img
Summary of Contents for SBC8600B
