We recommend connecting any home theater media center computers,
or appliances containing a hard drive into the Always On outlets. We
recommend connecting home theater projection equipment which
require a cool down period to the Always On outlets. This will prevent
damage to, and extend the life of your home theater projection lamps.
Embertec Emberstrip® 8AV+ has 2 power saving functions
1.
Standby Powerdown automatically detects and saves power
wasted when equipment is left in standby mode, by switching the
power off to the equipment.
2.
Active Powerdown® automatically switches the power off to Audio
Visual (AV) equipment connected to the Power Saving outlets
after 1 hour, if it has not detected any remote control use.
NOTE:
The Embertec Emberstrip® 8AV+ is programmable and
has an Active Powerdown® default setting of 1 hour, which can be
permanently set to 2 hours, or temporarily 8 hours (MusicMode™).
When will Active Powerdown® switch the Audio Visual (AV)
equipment off?
•
If your Embertec Emberstrip® 8AV+ detects that your Audio Visual (AV)
equipment is on but has not been used for a period of 1, 2 or 8 hours
(depending on your settings), the LED light on the Classic Sensor will flash
for approximately 10 minutes to warn you that power down is imminent.
To continue using your equipment
•
Simply press the volume button on ANY of your existing remote
controls or press the button on the Classic Sensor once. This will
cancel the Active Powerdown® and reset the timer to 1, 2 or 8 hours
(according to your existing setting).
NOTE:
A flashing LED always means that your system will shut
down completely in a while. Press any remote control button to
stop the light flashing and continue using your system.
TO CONTINUE
USING YOUR
EQUIPMENT
A flashing light means
the system is getting
ready to shut down.
Press the volume
button on your
remote control.
8
