Tinyhawk II Race
4
emax-usa.com
Tinyhawk II Race
VTX Settings
NOTE:
Under normal operating conditions, please use the Betaflight OSD function to
change VTX (video transmitter) settings. Only use the VTX push button to unlock as
allowed for under the FCC and HAM licensing requirements, see below. If using the
VTX push button to change settings, please note that the settings will revert to the
Betaflight OSD's settings once the drone is power-cycled.
VTX Schematic and Button Diagram
VTX Channel Settings with the Button
1. Normal display
When powered on, the parameters of frequency group band, frequency point and
power are displayed twice by LED cycle., then the LED is extinguished. To check
frequency group band ,channel and power status click the button once quickly, and
LED starts to indicate frequency band band , frequency channel and power. First
indicate the frequency group band and then indicate the frequency channel, final
indicative power. After all 2 rounds of LED display cycles, all LED will be off.
2. Menu Entry / Exit
(1)Press the button and hold for 5s to enter the menu. After entering the menu,
band LED lights up.
(2)Press the button and hold for 5s again to save parameters and exit the menu.
After saving and exiting the menu, all LED goes out.
3.Enter/Exit Band / Channel / Power option
(1) After entering menu, short click button to switch frequency group band /
frequency point / power, and the LED of the corresponding menu is lit.
(2) Press the button and hold for 2s to enter frequency group band / channel /
power option.
