4
Gas Powered 3-in-1 Compressor / Generator / Welder
A
B
C
E
Y
D
G
H
I
J
K
L
M
N
O
F
Y
Z
fig.1 Compressor/Welder/Generator: main areas
Functional Description
The EGES14020T was designed as a mobile and stationary power source, providing power in the form of
either compressed air or electricity, to drive pneumatic and electrical equipment, or for welding metals. Its
base motive force is provided by an air-cooled 4 cycle 14 horsepower Kohler gasoline engine. In common
with most generators, the engine is regulated to respond to demand, powering up when needed to produce
electricity or air, and running at idle until needed again. As a compressor, it can provide an air volume of 16.8
scfm at 175 psi and with a 20 gallon reservoir. The generator produces 5000 continuous watts (5500 peak
watts) of AC electrical power. Its electrical output will enable 190 amp DC stick welding with an 80% duty
cycle.
Please use the photos below, opposite, and on the following pages to familiarize yourself with the various
functions and locations of the salient parts of this unit.
The compressor pump on this unit is oil lubricated, which gives a superior pump
life, but, should an application be contemplated which requires oil-free air, an
approriate filter must be applied to the air produced.
While running the generator and welder, the engine must be at full throttle to
maintain 60 Hz electric power plus 190 amp welder. This will keep from damaging
the generator, welder or the equipment it is operating.
NOTICE
NOTICE
