1.Use ONLY ICF system components; Locking Ring unit doing assembly, metal-reinforced seal. Non-tighten
locking ring components may fail in use and cause explosive component separation. Verify that upper and
lower filter bodies are properly secured with the filter body locking ring unit. Make sure hand tightening
enough the locking Ring enough to the filter upper and bottom body. Verify that the filter manual air release
valve is in the LOCK position, and no filter components are missing, damaged, or not genuine ICF filter
components.
3.1 BEFORE STARTING THE PUMP
STARTING THE PUMP AND FILTER SYSTEM P6
3. STARTING THE PUMP AND FILTER SYSTEM
2.Close filter drain. Note: Filter plug requires an O ring seal.
3.Open all system valves to allow water from the pool to the filtration system and from the filter to return to the
pool.
4.Place the manual air release valve in an OPEN position.
Figure 3
Figure 2
Figure 1
Sealing O ring
Drain Plug
Locking
clamp
Bottom base
Clamp bolt
Upper body
Clamp nut
Relief valve
Release direction
P9 MAINTAINING YOUR FILTER
Notice: Do not use any petroleum solvents to clean filter components
Do not lubricate sealing O ring.
If the O ring is damaged, it must be replaced
4.4.3 BODY AND LOCKING RING REASSEMBLY
1.Place the Sealing O Ring on the lower filter body.
2.Place the upper filter body on Sealing O Ring and lower filter base in a position that allows all operation and
safety labels to be visible and the upper filter body to be centered on the lower filter base. Press down firmly and
evenly on the upper filter body to seat the seal.
NOTE: If the O-ring is damaged it must be replaced
4.4.4 VACUUMING POOL
Vacuuming can be performed directly into the filter whenever needed.
Clean cartridges after vacuuming, if required.
3.Replace the filter clamp around the upper and lower filter bodies. Hold the clamp ends in position while
reinstalling the bolt and nut
Tighten the nut and bolt with a torque wrench
DO NOT HIT OR STRIKE CLAMP WITH HAMMER OR METAL TOOLS.
4.Follow Operation Instructions for “Starting the Pump and Filter System” .
Figure 7
Tighten clamp bolt
And nut using a torque wrench
Figure 6
Top filter body
Clamp unit
Top Closure Plate
Sealing O ring
Bottom base
Sealing surface
Clamp bolt
Clamp nut
Clamp
The fluted side of the rubber washer faces down
