4. INSTALLATION
1. Remove the mounting bracket from the control box,
position the mounting bracket to the desired fitting
place and mark on the wall with the location of the
drilled holes.
2. Then drill 4 holes of ø8mm on the marked position
and insert a plastic fitting, Secure the mounting
bracket by fastening 4 screws of M5x35 to the
plastic fittings as figure.
3. The ColorTouch control box is hanged on the hook of
mounting bracket, and secure the bottom screw.
INSTALLATION P4
CONTROL BOX DISPLAY AND FUNCTION KEYS
Remote Handset
Reset Button
All Button
Z2 Button
Z1 Button
Main Power Switch
Power Cord
Zone 2 Output
Zone 1 Output
Lean key
Lean key Display
Standby ON/OFF Button
Color Wheel
Batter y Compartment
RESET
Z1
Z2
ALL(Z1+Z2)
Brightness
Mode Display
P7 COLORTOUCH REMOTE HANDSET
1. Long touch reset button will change the ColorTouch remote
to E- Lumen mode, the display LED at the center of color
wheel will turn to green color flash.
2. The color wheel buttons and brightness function will be
disabled.
3. Touch Z1, Z2 and all button will change the Zone 1, Zone 2 or
Both Zones color one by one.
4. Reset button will turn all the light color to light’s default first
color for RGB color light.
It is the default control mode after learning.
1. The mode display LED under at the center of color wheel will be flashed in
red color and ready to touch.
2. The ColorTouch remote choose direct color pick up just by touch the color
area.
3. The rainbow color key is a toggle key for multiple modes of auto color
change.
4. There are three level of brightness for light brightness adjustment by touch
the desired brightness button.
5. Z1, Z2 and ALL are ON/OFF switch to ON/OFF Zone 1, Zone 2 and both
Zones. The Reset key will turn Z1 and Z2 lights back to Cool White. It will take
three seconds to the light up after switch off.
6. Touch any key and wait for a while for light response.
6.2.1 COLORTOUCH MODE
Put the finger on the top of button and touch it gently, then
remote from it. Keep touching the same button will interrupt
the handset operation.
6.2.2
BASIC MODE
6.3 BATTERY REPLACEMENT
Reverse the remote and open the batter y compartment by pushing the right
hand side lock inward. The remote use CR2032 batter y that life time is around
six months.
The Color Touch Control Box main power switch must be
switched off and wait for three minutes and then switch on
again.
