1
2
3
4
5
6
7
8
9
10
11
2) Before replacing O-ring make sure the all liquid has been
discharged (by removing the bottom drain
plug).
3) Replace the o-ring and lubricate the surface of the
o-ring before closing the Lid.
4) Fasten the bottom drain plug.
5) Follow the steps under “CLOSING THE FEEDER LID”.
Warning:
WINTERIZING
When cold weather is forthcoming, drain all water in the feeder by loosening the Bottom Drain
Plug. Open the feeder lid and with chemical resistant gloves on carefully take out the
undissolved tablets and rinse the feeder thoroughly with water then put the cover back.
INSTALLATION
Always install the chlorine feeder after the heater. If there is no heater, install after the filter.
Position the chlorinator on level surface as close to the filter and pump as possible. The
preferred installation is above water level and below filter or heater outlet (Figure 1); or is
offline with feeder inlet connecting to the pump outlet and feeder outlet behind the heater
outlet.
An inline positive seal corrosion-resistant check valve is to be installed to reduce backflow of
chlorine gas when the system is shut off and to control the follow of water to the feeder. If the
chlorine feeder must be located below water level, a check valve is needed to prevent water
backflow when opening the unit as well as to control the flow of water.
The CLL series feeders feature with two inlets, either one can be chosen to meet the
installation requirements and seal the other with the supplied plug and PVC glue.
Note: After installation start up the system to perform leakage check, re-tighten if required. This
installation can only apply to imperial/metric 1.5” pipes. The feeder can be fixed onto the
installation surface by tapping screws and 4 securing holes in its base.
DO NOT use petroleum type of lubricants on the
O-ring. Silicone Grease is recommended.
2
VALVE
(
NOT
INCLUDED)
CHECK VALVE
FROM
POOL
FILTER
PUMP
HEATER
INLET
FEEDER
RETURN
TO POOL
Figure 1
CLL-50 / CLL-75 PART LIST
Item
Part No.
Description
Qty
1
89440309 Drain Plug with O-Ring
1
2
89440313
Connector for Pressure Gauge/Stopper
with O-Ring (Viton)
1
3
89440310 Air Release Valve with O-Ring
1
4
01021006 Ring Lock for Cartridge Filter
1
5
01011020 Lid
1
6
02080003 O-Ring for Lid
1
7
89440301 CLL-50 Diffuser Assembly
1
7
89440302 CLL-75 Diffuser Assembly
1
8
89440311 1.5" Union
2
9
89440303 CLL-50 Feeder Body
1
9
89440304 CLL-75 Feeder Body
1
10
01011015 Plug
1
11
89440312 Air/Water Release Valve with O'Ring
1
