(3) Code learning operation between remote controls: Used to unify system code values or copy a new remote controls.
Since each remote controller has its own unique code at the time of deliver y, when there are multiple remote controllers
in one system, one of them (for example, remote controller A) must be selected as the system code value, and the code
value of the rest remote controllers (for example, remote controller B) should be copied to the same one.
Step
Operation
Instructions
1
A remote control
：
Press and hold “ON” on the remote control
for 5 seconds, the indicator of the remote control will flash
quickly, means it enters the pairing code transmission status.
Will automatically exit code transmission
status after 60 seconds, or pressing any key
to exit.
2
B remote control: long press "mode key" for 5 seconds, the
remote indicator light changes from 100% light to 5% light
and flash, means entering the code value receiving state
Will automatically exit the code value
receiving state after 30 seconds, or exit after
learning the code value successfully.
3
see the B remote control indicator light flash 3 times
Code copying is finished and exit code value
receiving status.
(4) (4) Copying code from receiver to remote control.
A new remote control can also copy code from any one of the receivers in the whole system, after the successful
operation, the new remote control can replace the original remote (if it is lost).
Step
Operation
Instructions
1
Cut off the power of receiver.
Which one will be controlled by remote.
2
Long-press "mode key" for 5 seconds, the remote indicator
light changes from 100% light to off, means entering the
code value receiving state.
Will automatically exit the code value
receiving state after 30 seconds, or exit
after learning the code value successfully.
3
Power on the receiver, will see remote control indicator
light flash 3 times.
Code copying is finished and exit code
value receiving status.
* For security of the system, the distance from remote control to the one receiver should be less than 2 meters in this
operation.
*Only one time operation is requested for the whole system, no need different operation for different zones.
(5) The remote control restores the factor y setting: it means that the remote control will be restored to the factor y's
unique code value.
Step
Operation
Instructions
1
Long press "mode " for 20 seconds.
The remote indicator light dim down and
flashes continuously until the 20th second
and then back to 100% light. Means this
step is finished.
2
Press the "OFF" to confirm, the remote indicator light
flashes 3 times.
Restore factor y settings successfully.
7.1.4 Remote control accessories installation instructions
Accessories include bracket 1pc, 3M foam sponge glue 1pc, screw 2pcs, expansion tube 2pcs.
There are 2 options for bracket installation:
1) Using screw and expansion tube make drilling installation (suitable for uneven and ash surface);
2) Using 3M foam sponge glue make free drilling installation (suitable for flat no ash surface).
P9 DIMMER AND REMOTE OPERATION
