EMAK 654 Series, Operator Instructions Manual

Page: 25 / 120

GB
25
13. TROUBLESHOOTING CHART
WARNING: always stop the machine and disconnect the safety connector before carrying out the corrective
checks recommended in the table below, except when they require the machine to be in operation.
When you have checked all the possible causes listed and you are still experiencing the problem, see your Servicing Dealer. If
you are experiencing a problem that is not listed in this chart, see your Servicing Dealer for service.
PROBLEM POSSIBLE CAUSE SOLUTION
Engine will not start or will run only
a few seconds after starting.
1.
Battery drained or fitted incorrectly
2.
Power cable damaged.
3.
Motor protector triggered due to
engine overheating.
4.
Safety plug not inserted
5.
Starting lever microswitch damaged
6.
Damaged battery
1.
Charge the battery or fit it correctly
2.
Have the cable replaced by an Authorised
Service Centre.
3. Wait several minutes before restarting the
machine.
4.
Check and/or insert
5.
Contact an Authorized Service Centre
6.
Contact an Authorized Service Centre
Engine starts and runs, but blade is
not rotating
WARNING: Never touch the
blade while the engine is
running.
Switch off the motor immediately and contact
an Authorised Service Centre.
WARNING! Also read the battery and battery charger instruction and maintenance manual!