Emagic Logic fun, User Manual

Page: 124 / 256

120
Chapter 7
Arrange Window
Emagic
Logic fun
You can activate the loop function for selected sequences by
setting the parameter for Loop to On.
The repetitions are graphically shown as gray boxes.
Use the loop function when certain passages are to be repeated
exactly. Loops do not require any memory.
Another advantage is that any changes made to the original
sequence automatically affecrt all its loops.

Please be careful not to confuse “Loop” with “Cycle”. “Cycle” repeats an entire
piece of a song, including corresponding jumps in position. “Loop”, on the other
hand, continuously repeats individual sequences. The song plays from beginning to
end.
Stopping Loops
Normally the loop will repeat until the end of the song.
However, you can stop the loop at any time by placing another
sequence in the track at the position where you wish to stop the
loop.
To do this, simply insert an empty sequence at the spot where
the loop should be stopped. You may also copy or record a
sequence at the point where the loop is to be stopped.
Transpose
With the Transpose sequence parameter, you can transpose
sequences in half tone increments. The possible range is ± 99.
The value-12 corresponds to a transposition of one octave
lower. If you want to transpose an entire section of song, select
all of the sequences for the section, and transpose these to the
desired value. This procedure is very practical, if you want to
Important!