EN
6.5 Disassembly and Storage of the BioProTT
TM
Clamp-On SL
It is best to disassemble and store the sensor once the measurement process
has been completed in order to not impair the measurement and to protect the
BioProTT
TM
Clamp-On SL from damage.
To disconnect the BioProTT
TM
Clamp-On SL, follow these steps:
1.
Open the spring-loaded lock and swing back the lid.
2.
Remove the tube from the channel.
3.
Close the lid and carefully remove the plug from the sensor connection on the evaluation device as to
not risk any damage to the sensor or the plug.
Once you have disconnected the BioProTT
TM
Clamp-On SL, check for any residue of the medium or any other
kind of dirt or grime and clean the sensor if necessary. Store the sensor according to storage specifications.
Make sure to store it in a place where it cannot fall off or be dropped and ensure that the plug is dry.
6.6 Cleaning and Disinfection of the BioProTT
TM
Clamp-On SL
Make sure that no detergents or disinfectants leak into the sensor plug.
For the cleaning of the device, we recommend commonly used detergents and/or the recommended
disinfectants stated below. In order to avoid stains and dirt from drying out, grime residue should be removed
after each application.
To clean the BioProTT
TM
Clamp-On SL, use a lint-free cloth. Be sure to remove any dirt in the clamping area.
Additionally, please follow the legal regulations valid in your country and the hygiene regulations for your
specific application.
•
The BioProTT
TM
Clamp-On SL may not be submerged into cleaning or disinfecting solution.
•
The BioProTT
TM
Clamp-On SL is not suited for cleaning processes using machines. Sterilization
processes, especially steam sterilization or autoclaving, may not be used.
The following surface disinfectant is recommended:
Name
Manufacturer
Contact
Bacillol® AF
Hartmann
www.hartmann.de
BioProTT™ Clamp-On SL
Page 14
Copyright em-tec GmbH
D162-704 BioProTT™ Clamp-On SL – User Manual– V4.0
DocuSign Envelope ID: BE88571C-E493-4DFB-AF9A-864EB3FC3D75
