9
EN
4 Installation
Before start, please make sure that the wall or ceiling is strong enough to withstand 3 times the weight of the camera. Please
install and use the camera in the dry environment. You’d better install back the lens cover less than 4 hours after removing it.
The mounting steps are as follows:
1) Drill the screw holes and the cable hole on the wall according to the drill template.
2) Route the cables and connect the power cable and video cable.
3) Secure the mounting base with camera to the wall with screws as shown below.
4) Bracket adjustment. Before adjustment, preview the image of the camera on a monitor and then loosen the fixed ring to adjust
the view angle of the camera.
r
r
r
5) Focus and zoom adjustment (If the model you get is fixed lens, please skip this step). Remove the lens cover and then adjust
the focus and zoom screws to get a clear image. Finally, tighten these two screws and the lens cover.
Lens cover
Zoom
Focus
6) Remove the protection film softly to finish the installation.
PAN
Fixed screws
Tilt
Rotate