51
GB
FINE-TUNING THE DRYING PROGRAMME
It is possible to fine-tune the two automatic
programmes to get the best results.
The settings for each programme are adjusted
using the control panel.
You should only do this if you feel that:
• The laundry is not being dried adequately.
• The laundry is being over-dried, or the
drying time is too long.
Introduction
The drying cabinet has two automatic programmes:
Normal dry
and
Extra dry .
The automatic programmes stop the drying process automatically when the laundry is dry.
To decide when the laundry is dry, the measured value is compared with a default setting.
Parameter
P 2072
is used for the
Normal dry
programme, and parameter
P 2071
is used for
the
Extra dry
programme.
These are the two main parameters that can be adjusted to optimize the drying process.
• If you feel that the laundry is not being dried adequately by the:
Normal dry programme
reduce
the parameter value for
P 2072 .
Extra dry programme
increase
the parameter value for
P 2071 .
• If you feel that the laundry is being over-dried by the:
Normal dry
programme
increase
the parameter value for
P 2072 .
Extra dry
programme
reduce
the parameter value for
P 2071 .
The drying process should always be adjusted in small steps; start by adjusting the current va-
lue by 1–2 units up or down, then check the results from the next drying cycle and make further
adjustments if needed.
Method
The parameter list can be accessed using the
control panel. The list is displayed as follows:
the top row shows the current parameter, e.g.
P 2071, while the bottom row shows the set
value.
1 Make sure the ON/OFF button on the
cabinet is turned off. The display should be
dark.
2 Press and hold the ARROW UP and
ARROW DOWN buttons and press the
ON/OFF button to turn the cabinet “ON”.
The display will light up and show “P 105”
and the default setting for P 105. The row
with the current parameter will flash in the
display.
3 Advance to the desired parameter by pres-
sing the ARROW UP or ARROW DOWN
button repeatedly. If you go too far you can
simply continue scrolling until the display
shows the right parameter.
4 When the display shows the desired para-
meter, e.g. “P 2072”, press START/STOP
to confirm.
The row showing the set value for this pa-
rameter will now flash.
5 Increase or decrease the value using the
ARROW UP or ARROW DOWN buttons.
6 To save the set value, press START/STOP.
7 To return to the operating value, press
ARROW DOWN and START/STOP.
Restoring default settings
1 Enter parameter display mode as described
in steps 1–2 above.
2 Press and hold the ARROW UP and
ARROW DOWN buttons and then press
START/STOP.
The default settings are restored and the
display shows the last-used programme.
