elvita CDI4601V, User Manual

Page: 81 / 142

GB
81
Starting a wash cycle
1. Pull out the lower and upper baskets, load the dishes and push the baskets back in.
It is recommended that you load the lower basket first, then the upper one.
2. Pour in the detergent.
3.
Insert the plug in the socket. For information on the electrical supply refer to the last page “Product fiche”.
Make sure that the water supply is turned on at full pressure.
4. Close the door and press the Power button to turn on the machine.
5. Choose a program; the indicator light will turn on. Then press the Start/Pause button; the dishwasher will start its cycle.
Changing the program mid-cycle
A wash cycle can only be changed if it has been running for a short time, otherwise the detergent may have already been
released and the dishwasher may have already drained the wash water. If this is the case, the dishwasher needs to be reset
and the detergent dispenser must be refilled. To reset the dishwasher, follow the instructions below:
1. Open the door a little to stop the dishwasher. After the spray arm stops turning you can open the door completely.
2. Press the Program button for more than three seconds to put the appliance in standby mode.
3. You can now change the program to the desired program setting.
Forget to add a dish?
A forgotten dish can be added any time before the detergent dispenser opens. To do this, follow the instructions below:
1. Open the door a little to stop the wash cycle.
2. After the spray arm stops turning you can open the door completely.
3. Add the forgotten dishes.
4. Close the door.
5. The dishwasher will run after 10 seconds.
WARNING
It is dangerous to open the door mid-cycle, as hot steam may
scald you.
3 sec