30
Installation
© 2021, Elon Group AB. All rights reserved.
1.
Turn the front feet to adjust the height.
2.
Turn the wheel adjustment screws to adjust the height of the rear wheels.
3.
Place a spirit level on top of the cooker to check the horizontal position. Adjust if needed.
4.
Place the blind plugs into the holes.
Connect the mains power
Connect the cooker to either a single-phase or a three-phase power supply.
WARNING!
Risk of electric shock! Do not connect the product to the mains yourself. The product may only be connected
by an authorised technician.
WARNING!
•
The electrical installation must follow local regulations.
•
For single-phase power supply, use a 3×4.0 mm
2
cord marked H05VV-F 3G4 or better.
•
For three-phase power supply, use a 5×1.5 mm
2
cord marked H05VV-F 5G1.5 or better.
•
Do not use external timers or separate remote control systems to control the product.
CAUTION!
Carefully read the instructions for use before connecting the appliance. Repair or any warranty claim resulting
from incorrect connection or use of the product shall not be covered by the warranty.
Connect to a single-phase power supply
Follow these instructions to connect the cooker to a 220-240 V, 50-60 Hz, single phase power supply.
1.
Remove the clamp protection cover.
2.
Open the terminal board cover.
3.
Install the bridges.
4.
Secure the cable wires to the terminal board using the screws.
WARNING! Make sure the protective earth wire is properly secured.
5.
Secure the cable with the clip.
6.
Close the terminal board cover.
7.
Install the clamp protection cover.
Connect to a three-phase power supply
Follow these instructions to connect the cooker to a 380-415 V 3N~, 50 Hz, three phase power supply.
