www.prolight.co.uk
Kudos 700 Beam
User Manual
10
Operating instructions
Control Panel Menu:
The LCD control panel situated on the front of the fixture allows the user to access the menu system to
adjust the fixtures settings.
When the unit has been powered on the display will show
“eLumen8 Kudos 700 Beam”, “System
Initialising...”
whilst the unit performs its motor reset. The fixture will then return to its home screen.
Pressing the
“MENU”
button once will take the user to the fixtures main menu. Using the
“UP”
and
“DOWN”
buttons you can then navigate between the different options in the main menu. Pressing the
“ENTER”
button on one of these options allows you to access the sub menu where you can use the
“UP”
and
“DOWN”
buttons to select option/value required. Once the option/value has been selected
press the
“ENTER”
button once more to confirm the setting.
To exit out of any of the above options, press and hold the
“MENU”
button.
Error Codes:
When the unit is powered on the unit will automatically perform a motor reset. If there is a problem
with any of the motors you will need to check the Error Log once the home screen appears.
To do this follow the instructions on page 17 (Error Log) to show what error has occurred.
Home Screen:
Please see the diagram below with a key to what the sections of the home screen mean.
MENU
ENTER
UP
DOWN
001
Kudos 700 Beam
SYS: Ready
CHL: 18CH
DMX:
Fail
TEM: 28°C
02
05
04
01
03
01 - DMX Address - This can be adjusted in the DMX Address
Menu (see page 11).
02 - SYS: Ready - This indicates the unit is ready to use.
03 - CHL: - This is the DMX Channel mode the fixture is
currently in, either 12CH or 18CH.
04 - DMX: This will either show Fail (there is no DMX signal)
or OK (there is DMX signal).
05 - TEM: - This shows the fixture temperature.
