www.prolight.co.uk
Alu Quad Par 64 MKII
User Manual
6
Colour fade mode:
To access the static colour mode, press the
“MODE”
button to show
“FADE”
on the rear of the unit.
You can then use the enter button to select and set the desired fade from
“00” - “99”
, Then press the
“ENTER”
button to set the flash speed from
“01” - “99”
.
Press the
“ENTER”
button to confirm any settings.
To exit out of any of the above options, press the
“MODE”
button.
Auto mode:
To access the static colour mode, press the
“MODE”
button to show
“AUTO MODE”
on the rear of the
unit. Press the
“ENTER”
button to confirm any settings.
To exit out of any of the above options, press the
“MODE”
button.
Master/slave mode
To set the unit to a slave, press the
“MODE”
button on the rear of the unit and set the address to show
“SLAVE MODE”
on the LED display. Press the
“ENTER”
button to confirm any settings. The unit will now
run in sequence with the master unit.
Sound active mode:
To access the sound active mode, press the
“MODE”
button on the rear of the unit to show
“SOUND”
on the LED display. The unit will now be in sound active mode. Press
“ENTER”
and use the
“UP”
and
“DOWN”
buttons to set the sound sensitivity level from
“SENS:00” - “SENS:31”
(00 = low, 31 = high).
Press the
“ENTER”
button to confirm any settings.
To exit out of any of the above options, press the
“MODE”
button.
DMX mode:
Operating in DMX control mode gives the user the greatest flexibility when it comes to customising
or creating a show. In this mode you will be able to control each individual trait of the fixture and each
fixture independently.
To access the DMX channel mode, press the
“MODE”
button on the rear of the unit to show
“DMX
MODE:1CH”
on the LED display, then use the
“UP”
and
“DOWN”
buttons to select either 2, 3, 3, 4 or 7
DMX channel modes.
To set the units address, press the
“MODE”
button on the rear of the unit to show
“ADDR:001”
on the
LED display, then use the
“UP”
and
“DOWN”
buttons to set the desired address from
“001” - “512”
.
Press the
“ENTER”
button to confirm any settings.
To exit out of any of the above options, press the
“MODE”
button.
