6
Assembly technology
© Copyright eltima electronic 2017
Corner connections
Two profile rails are connected by the means of angle brackets.
At first, insert two T-lot nuts at the end of the slot, see Figure 6.
The two threads of the nuts should point to the ends of the rail. This
is important, so that the angle can subsequently be pushed all the way
to the end of the rail.
Screw the bracket firstly with the outer screw, by turning it 1 to 2 turns, so
the bracket will still be loose, see Figure 5.
Then slide the bracket with the remaining hole over the second slot nut and
also loosely tighten the second screw, see Figure 4.
Now push the angle to the end of the rail.
Figure 6:
inserting the T-slot nuts
Figure 5:
insertig the first screw
Figure 4:
inserting the second screw