ELTEX flexBAR R60L Series, Operating Instructions Manual, Page: 15 / 32

BA-en-2082-2207_R60L
15
Locating the R60L discharging bar
The best possible discharging results are achieved if the bar is located in
areas with minimum web capacities. In practical terms this means placing
the bar with maximum distances from the machine environment, i.e. no
discharging against the idler roller.
A rough guideline:
A space with the radius R of the bar distance to the web ought to be kept
free of any conductive material (Fig. 5). The distance of the emission
points to the conductive, earthed printing press area should be greater
than to the substrate to be discharged.
Depending on application, the distance between R60L discharging bar
and substrate ought to be 100...1000 mm.
In bilateral discharging, the bars must not be mounted in opposition to
each other. The distance between both bars should be greater than twice
the bar distance from the web.
Fig. 5:
Zone free of con-
ductive material
with the dimen-
sions R
Z-
11
55
74cy_
3