Page 16
InWall-10
MANUAL
Rubber Band Clips
Installing in a cavity wall
Before installing the back box in a cavity wall, remove the break-out for
the cable outlets. Mount the protective card as a template and place in a
suitably dimensioned recess in the cavity wall. Make sure that the circuit
breaker is switched off. Route the power cables through the grommet in the
back box. Attach the Aluminium frame to the back box and place in the wall
recess. Cut the Aluminium foil covers on the sides of the back box. Route
the fastening clips and screw down tight. Make sure that the fastening clips
are not bent or distorted.
Installation
To install the iPad, plug the original Apple charging cable to the USB socket
of the supplied power supply adapter. Plug the Lightning connector to the
iPad. Then attach the iPad using the rubber band clips to the rear of the
glass cover. Make sure the clips are in the correct position. Fasten the cover
and the iPad to the Aluminium frame by contacting the magnet on the cover
with the Aluminium frame. Switch the circuit breaker back on.
If you need to remove the iPad needs from the docking station, use the
suction pad.
