!
■
Parameters for operating with FAH60
■
Parameters for operation of FWS61
■
Add or change sensors
When an actuator is ready for
teach-in (the LED fl ashes at a
low rate), the very next incoming
signal is taught-in. Therefore,
make absolutely sure that you
do not activate any other sensors
during the teach-in phase.
Cable fi xation
The cable must be fastened with standard
cable ties (width < 3,6 mm).
ELTAKO GmbH hereby declares that the
products that relates to this operating
manual, are in compliance with the
essential requirements and other rele-
vant provisions of directive 1999/5/EC.
A copy of the EU declaration of confor-
mity can be requested at the address
below.
Must be kept for later use!
Eltako GmbH
D-70736 Fellbach
Technical Support English:
Michael Thünte +49 176 13582514
[email protected]
Marc Peter +49 173 3180368
[email protected]
eltako.com
36/2016 Subject to change without notice.
