Using the Remote Control
Unless stated other wise, the remote control can operate all the features of the DVD Player, Always point the
remote control directly at the remote sensor on the front of the DVD Player, not the TV.
Battery Installation
Remove the battery compartment lid on the rear of the remote control by sliding the lid down, then off.
Place two AAA batteries inside the battery compartment with their + and ends aligned as indicated.
Do not mix old and new batteries or different types of batteries
Replace the battery compartment lid. Slide the lid until you hear it click into place.
4.CONNECTIONS
Before connecting, make sure to turn off power of all apparatus.
After finishing connection, turn on the power again.
Wires must be connected properly, depended on the silkscreen on the rear panel. Especially the play shall be
fully inserted.
Warning:
Do not connect any amplifier with coaxial connector that does not contain Dolby digital AC 3 or DTS decoder.
Any attempt to do so and play of DVD disc will result in damaging your speakers and causing possible hearing
injury. Other than DVD disc, VCD and CD can be operated normally without conforming to the above
restriction.
Setting of TV system
If you find the image like non-fully zoomed picture, brim picture covered or black & white picture etc, please
select PAL or NTSC by systems setting or press
N/P
button to switch the TV system on the remote control.
This DVD disc is capable of supporting different scales picture, as a result, non-full zoomed picture could
appear or picture be partially covered on user’s TV set.
5. FUNCTION OPERATION
How to program playback
In complete stop state( press
STOP
button twice), press
PROGRAM
button enter the Play Mode menu (for
VCD)
GB-7
