117
Automatic
CasaConnect KNX Control Center
• Version: 13.09.2021 • Technical changes and errors excepted.
Default setting: 6.0 m/s.
If the shade should not react to the wind (e.g. for indoor awnings, shutters), switch the
wind alarm
OFF
.
The wind alarm protects sensitive curtains from wind damage by retracting the shades.
A wind alarm actuated for the motor will remain active for 5 minutes. In addition, a
wnid delay can be set for shades. After the end of the wind alarm, the automatic con-
trols are switched off for the specified period. Manual operation is already possible
again, however.
System > Set automatic > General settings > Wind delay
6.3.8. Set wind delay (shades), Page 109
Rain alarm:
Shows whether the rain alarm is switched on. Touch the field and switch the rain alarm
on or off for this shade.
Default setting: No.
The rain alarm protects sensitive curtains from rain by retracting the shades.
The rain alarm can only be activated if the rain automatic is deactivated.
Automatic reset:
Shows which automatic resets apply to these shades. Touch the field in order to acti-
vate the daily automatic reset and/or reset after a manual operation.
The general Automatic Reset occurs daily at the same time. In addition, automatic
mode can be reactivated a certain period after a manual operation. You can set the time
or period for automatic resets.
System > Set automatic > General settings > Automatic reset
6.3.9. Specify automatic reset, Page 109
Manual switching:
Shows whether a position message is used by the motor to switch from automatic to
manual, i.e. whether automatic mode is switched off by pressing a button if there is an
external manual operation.
Default setting: No.
6.4.2. Set window automatic mode
System > Set automatic mode > Windows
You can change the following automatic settings for windows:
•
Indoor sensor is evaluated
•
Indoor temperature
•
Humidity
•
CO
2
(only if receiving CO
2
values via the bus)
•
VOC (only if receiving VOC values via the bus)
