Radio motor control unit RF-MSG-ST IP53
2
Radio motor control unit RF-MSG-ST IP53
• Version: 08.06.2020 • Technical changes and errors excepted. • Elsner Elektronik GmbH • Sohlengrund 16 • 75395 Ostelsheim • Germany • www.elsner-elektronik.de •
Technical Service: +49 (0) 7033 / 30945-250
2.4. Establish wireless connection
1. Set the control unit and/or remote control or the button to teaching mode (obser-
ve the corresponding manual/data sheet)
2. Switch on the
RF-MSG-ST IP53
voltage supply or interrupt it for at least 3 se-
conds if the unit is already supplied with power.
3. For 5 minutes after connecting the voltage, the
RF-MSG-ST IP53
will send a "Le-
arn" telegram every 10 seconds.
4. The wireless connection will be established automatically. For building control
systems, the display will display "Device is learning".
5. The
RF-MSG-ST IP53
will stop sending "Learn" telegrams once the reply "Lear-
ned" (for a learning process) or a control command is received (in the event of a
power interruption during operation).
2.5. Notes on mounting and commissioning
Device must not be exposed to water (rain). This could result in the electronics being
damaged. A relative air humidity of 95% must not be exceeded. Avoid condensati-
on.
3.
Disposal
After use, the device must be disposed of or recycled in accordance with the legal
regulations. Do not dispose of it with the household waste!
1 Neutral conductor
2 L
3 nc (not connected)
PE
Motor output
STAK3 coupling for
STAS3 plug
Input mains voltage
STAS3 slot for
STAK3 coupling
1 Neutral conductor
2 Up
3 Down
PE
Fig. 3
PE
PE
