6
Settings of the device
Starting position
The following may be read off and set on the display of the Power Supply System KNX
PS640+:
•
Reset of a line
•
Recall of the data memory with operating hours, overcharge, external electrical
surge, internal electrical surge, short circuit and excess temperature
•
Recall of the operating data bus voltage, bus current and temperature
•
Language of display
The display is dimmed after 60 seconds if during this period no key is pressed.
Line reset
In starting position, press key once.
Press key once more in order to get into the sector
“Line reset”.
Move the cursor (flashing rectangle at right edge) to
the desired setting with the keys or
and confirm
with key
.
Yes:
Reset is activated. The line is switched to neutral and shorted. The
basic setting displays: “Reset is active!”
No:
Reset not activated. The power supply system works in normal
operation.
30 seconds:
A reset of 30 seconds is started. Afterwards, the line is supplied
with voltage as usual. During the reset state, which lasts 30
seconds, the basic setting displays: “Reset active: XX sec”
(countdown).
With key , you return to the previous menu level.
elsner elektronik
KNX Power Supply
Normal Operation
Diagnostics >
elsner elektronik
KNX Power Supply
Normal Operation
Diagnostics >
Line Reset
> ™
Data Memory >
Operating Data >
Language
Reset: Yes ™
No
30 seconds
Reset not active!
