42
Parameter settings
Interface KNX B8-TH
• Version: 24.08.2016 • Technical changes and errors excepted.
5.10. Absolute humidity
The settings for the "absolute humidity" and other air humidity settings are only shown
if the circuit board sensor input has been set to "temperature and humidity sensor" in
the "General settings".
Decide which sensor is to be used for the calculation of absolute humidity. This selec-
tion also applies to the following comfort field settings.
Activate the readings for absolute humidity and set the send pattern.
5.11. Comfort field
The settings for the "comfort field" and other air humidity settings are only shown if
the circuit board sensor input has been set to "temperature and humidity sensor" in the
"General settings".
The settings made for "absolute humidity" regarding the relevant sensor also
apply to the comfort field settings!
The
Interface KNX B8-TH
can send a message to the bus if the limits of the comfort
field are exceeded. In this way, it is for example possible to monitor compliance with
DIN 1946 (standard values) or even to define your own comfort field.
Switching output sends on change and
periodically
Send switching output status
Switching output sends on change to 1
and periodically
if switching output = 1
send 1
Switching output sends on change to 0
and periodically
if switching output = 0
send 0
Absolute humidity applies for
(also applies to the comfort field)
Plug-in sensor • circuit board sensor
Use absolute humidity
No • Yes
Send pattern
• never
• periodically
• on change
• on change and periodically
On change of
(if sent on change)
0.1 g • 0.2 g • 0.5 g • 1.0 g • 2.0 g • 5.0 g
Send cycle
(if sent periodically)
5 sec • 10 sec • 30 sec… • 2 hrs
Use comfort field
No • Yes
