25
KNX Interface for WS1000
• Status: 15.04.2016 • Errors excepted. Subject to technical changes.
2.5.2. Wind sensors
In this menu you can set the evaluation of additional wind sensors by the control. A
wind sensor connected directly to the control can transmit data to the bus, a wind
sensor in the bus system can transmit data to the control. The reception of data from
the bus can be monitored. In this case, wind alarm will be triggered if data has not been
received correctly.
Wind speed:
If the wind sensor is connected directly to the control an transmits on the bus:
Wind direction:
Note:
The function „Wind direction: transmits on bus“ is not possible with P03i-GPS
weather station, as wind direction is not detected.
Transmission delays after power-up and
programming for:
Weather data
5 s • 10 s • 30 s • 1 min • … • 2 h
Functional blocks
5 s • 10 s • 30 s • 1 min • … • 2 h
Maximum message rate
10 • 20 messages per second
Weather data
• do not use
• send to bus
• receive from bus
Malfunction object
do not use • use
Locking object for all outputs
do not use • use
Blocking before 1st communication
(only if the locking object is used for all
outputs)
not active • active
Monitoring time for wind sensors 1...4
5 s • 10 s • 30 s • 1 min • … • 2 h
Wind sensor 1/2/3/4
• do nor use
• transmits on bus
• receives from bus (without monitoring)
• receives from bus (with monitoring)
Sending behaviour
• transmit periodically
• transmit on change
• transmit on change and periodically
on change of
(only if transmitting on change)
0.5 m/s • 1.0 m/s • 2.0 m/s • 5.0 m/s
Transmit cycle
(only if transmitting periodically)
5 secs • 10 secs • 30 secs • 1 min • … • 2 h
Use malfunction object verwenden
No • Yes
