![background image](http://html.mh-extra.com/html/elsner-elektronik/71280/71280_installation-and-adjustment_2396653040.webp)
38
Setting the parameters
Nunio KNX M-T push button
• Version: 25.02.2021 • Technical changes and errors excepted.
9.6.2. Control modes for drive control
Behaviour on button actuation in standard control mode:
Standard:
If briefly operated, the drive will move incrementally or stops. If operated longer, the
drive will move up to the end position. The time difference between "short" and "long"
is set individually.
Standard inverted:
When pushed shortly, the drive moves up to the end position. When pushed for longer,
the drive moves incrementally or stops. The time difference between "short" and
"long" and the repeat interval is set individually.
Comfort mode:
In the
comfort mode
actuating the button briefly, a bit longer and long will trigger dif-
ferent responses of the drive. The time intervals are set individually.
Short actuation
(shorter than Time 1): The drive is positioned step-wise and stopped.
Holding it slightly longer
(longer than Time 1, but shorter than Time 1+2): Drive run-
ning. Drive stops when the button is released.
Long holding
(release after Time 1+2 runs out): Drive moves independently to the end
position. The movement can be interrupted by a short tap.
short:
hold
Blind
Stop/Step
Up or down
Shutters
Stop
Up or down
Awning
Stop
In or out
Windows
Stop
Closed or open
Control mode
Standard
Behavior during button operation:
short = stop/increment long = Up or Down
Time between short and long
in 0.1 seconds
1...50; 10
Control mode
Standard inverted
Behavior during button operation:
short = Up or Down long = Stop/Step
Time between short and long
in 0.1 seconds
1...50; 10
Repeat the step command
for a long button press
every 0.1 s • every 2 sec; every 0.5 sec
Summary of Contents for 71280
Page 1: ...Nunio KNX M T Push Button Item number 71280 EN Installation and Adjustment ...
Page 2: ......
Page 47: ......