![background image](http://html.mh-extra.com/html/elsner-elektronik/71280/71280_installation-and-adjustment_2396653035.webp)
33
Setting the parameters
Nunio KNX M-T push button
• Version: 25.02.2021 • Technical changes and errors excepted.
9.5.
Temperature PI control – Controller
extension unit
Activate the control
Determine if this device should take over the temperature control (stand-alone control-
ler), or if the Cala display should act as an extension for operating another controller.
Here you can set if the regulator information is read and whether the setpoints should
be changed and transmitted when the +/- buttons are pressed.
The settings for the ‘controller extension’ option are described below. For configura-
tion as a stand-alone controller, please see Chapter 9.5.
The ‘temperature controller’ menu must be activated (see chapter 9.7.
39) to enable the use of this controller type.
Set the type of mode switching and the controller. For more information about these
functions, see setting the device as a stand-alone controller.
You may enter separate set point values for each mode or use the comfort set point as
a basic value. If you are using the basic value, only the deviation from the comfort set
point value is listed for the other modes (e. g., 2 °C less for standby mode).
If heating or cooling, specify how the status object should be analysed.
Use control
No • Yes
Intended as a
• Stand-alone controller
•
Controller extension
(for operating a
stand-alone controller only)
Controller information no later than after
5...60; Read 10 seconds
Change and transmit setpoints when oper-
ating the +/- buttons
No • Yes
Grading for set point changes
(If setpoint changes are transmitted)
1...50; 5 in 0.1°C
Switch mode via
• two 8-bit objects (HVAC modes)
• three 1-bit objects
Type of control
• Single stage heating
• Dual-stage heating
• Single-stage cooling
• Dual-stage cooling
• Single-stage h single-stage cooling
• Dual-stage h single-stage cooling
• Dual-stage h dual-stage cooling
Setting the nominal values
• separately
• with comfort set point as a basis
Summary of Contents for 71280
Page 1: ...Nunio KNX M T Push Button Item number 71280 EN Installation and Adjustment ...
Page 2: ......
Page 47: ......