Elsist Pure 1000, Instruction Manual, Page: 16 / 18

PURE 1000●2000●3000
LINE INTERACTIVE SINGLE-PHASE
SINEWAVE
Ver.00 09 March 2018
16
6.1 Accessories
MODEL PURE 1000 PURE 2000 PURE 3000
Instruction manual
●
Software
●
RS232 cable
1
USB cable 1
Input cable (IEC)
1
Output cable 2 (IEC)
2 (IEC)
1 Adapter High Current plug
6.2 RS232 port
The present UPS provides a standard DB9 communication interface on the rear panel, the definition of the pins
is as follows
:
PIN DEFINITION
1-4-6-7-8-9 Not used
2 TX
3 RX
5 GND
When connecting the UPS to the PC via RS232 cable, it is necessary to use the standard RS232 cable, the
exact connections of the cable are as follows:
CONNETTORE 1
(female)
serial port PC side
CONNETTORE 2
(male)
serial port UPS side
2 2
3 3
5 5
6.3 Optional interface communication
1. USB communication interface
Install UPSilon2000 monitoring software supplied with the UPS. You can check directly the UPS
parameters from the PC. If both the RS232 cable and the USB cable are supplied, as only one is
possible to use, the USB cable is recommended.
2. Intelligent slot
The following boards can be installed in the UPS intelligent slot: SNMP board. The card can be
removed or inserted with the UPS ON. Depending on the needs of users you can use any of the listed
tabs.
2.1 SNMP card: When you connect to the internet with the SNMP card, you communicate with the
computer to monitor the power network and the status of the UPS remotely .
NOTE:
Remove the metal cover (Intelligent Slot) before installing the optional board.
The optional card slot can be used simultaneously with the RS232 port.
For the operating instructions of the SNMP card, refer to the instructions supplied with the card