3
Manual Binding
1. Repeat steps 6 to 8 of the Binding with ELRO Smart Home Alarm section.
2. Press and hold the learning key “F” (as shown in Figure 4) for more than 3
seconds until the green strobe LED turns off, then quickly release the
learning key. The Green LED will flash repeatedly. This implies it has now
entered the binding mode and is waiting to receive binding signals from
the gateway.
3. Within 5 seconds the green LED will stop flashing indicating the learning
procedure is completed. The screen below will appear indicating the
process is successful.
Testing
AS80SR11A can be tested with ELRO Smart Home Alarm smartphone App
by changing the security mode between ARM and DISARM on the App and
the listening for voice indication from AS80SR11A
If there is no response please check the “Troubleshooting”.
Mounting
It should be mounted inside the building in a position that is clearly visible and
at a height which is relatively inaccessible to an intruder. It is also suggested
not to mount the unit in the basement to avoid poor transmission.
1. Use the backplate as a template to mark and drill the position of 3 mounting
holes on the wall. Fix the backplate to the wall using the plastic wall plugs and
fixing screws provided.
2. Slide the unit down to the backplate and fasten the locking screw clockwise.
