SP105
1x6 VIDEO & AUDIO DISTRIBUTION AMPLIFIER
ELPRO Video Labs s.r.l.
Str.da della Pronda, 45/B 10142 TORINO - ITALY
Tel.+39 0117701583 – Fax +39 011703751
5
2.0 INSTALLATION
3.1 Video
section
In a classic installation with a composite video signal to be distributed towards
6 destinations, follow the procedure described below:
a) Make sure that all the units to be installed are OFF.
b) Connect the video source to one of the two “VIDEO IN” BNC
connectors
c) If the input signal is not terminated at 75
Ω
, set the switch to the side of
the input to the ON position. If the signal is already terminated at 75
Ω
,
set the switch to OFF.
d) The input BNC not used can be left free or can be used, if necessary, to
send the video signal to other units. In this case, remember that
termination at 75
Ω
must be carried out at only one point of the chain,
preferably at the end of this. Therefore, in this case, the 75 Ohm switch
must be set to a OFF.
e) Connect the destinations to the BNCs 1÷6 “VIDEO OUTPUTS”
f) Power the SP105 and other system units.
