Page 10/20
CA-6003Bi
12.2007AG
Operating Manual ET1-D / ET2
Datalogger HAMSTER-E ET1-D / ET2
Datalogger HAMSTER-E ET2; Part-No 4902
Datalogger for temperature with display
1. Introduction
The datalogger ET1-D measures and records temperature values by the built-in
sensor. The datalogger ET2 measures and records temperature values by two
external, plug-on sensors.
Measured values are displayed on the two-line LCD display and are stored in the
internal non-volatile memory. A PC is used for programming and evaluating of the
datalogger. The datalogger may be used in loop- or start/stop mode (see chapter 2.2). For
power saving reasons, the display may be switched off.
Alarm function: by exceeding preset limits, the logger is going to show an alarm
indication on the display.
Logging mode: In loop mode, the oldest stored value is overwritten by a new one at
the time the memory is full. In Start-Stop mode the logging stops after filling the memory.
Stored values are transferred from the logger memory to the PC by a data cable. The
data cable may be left on the logger permanently; data logging is not interrupted even data
is downloaded.
Battery: LOW BATTERY warning in the display. The remaining battery capacity (%) is
going to be shown in the display after reprogramming the datalogger, or is indicated in the
datalogger status information (elproLOG software).
This product has to be disposed according to WEEE
(Waste electrical and electronic equipment, 2002/96/EC)
- This product must be certified with CE.
- The manufacturer guarantees that this product complies with the relevant
recommendation: EN 61326 : 2002
