7
ELPRESS MINI | INSTRUCTION FOR USE
4.1 Service and maintenance
The MINI-tool shall be cleaned and dried after use. The axle for the fork in
the PVL350 and PVL130L shall be lubricated regular.
We recommend that the tool is send to an Elpress authorized service centre
or Elpress service department for service one time per year or more often if
the tool is used more than normal.
The only thing that the user can change is the die- and battery.
Do not damage the tools sealing, the guarantee is then no longer valid.
Service must be performed by Elpress Service department or an Elpress Aut-
horized Service center. Service inteval 10000 cykles.
4.2 Battery and charger
The battery charger is run with a nominal voltage of 230 VAC
(50 eller 60 Hz).
New batteries must be charge before use. The battery is loosening with the
button (5), see page 4. Charging time is approx. 40 min.
The charging level of the battery can be checked by the Light Emitting Diode,
LED on the charger:
1.
The charger is connected to AC power and ready for loading
2.
The charger is faulty
3. Charging
4.
The battery is fully charged
5.
The battery is missing
6.
The battery is too hot or too cold
7.
Note! Remove the battery from the charging unit when not connected to the mains.
The battery could otherwise be destroyed by deep discharge
LGML1
Li-Ion Charger
3
1
4
5
6
7
2
