www.elorapower.com
ELORA 3 STATION CHARGING CABINET
Owner’s Manual
|
10
SPECIFICATIONS
INSTALLATION INSTRUCTIONS
FOR WALL MOUNTED ELORA
CHARGING CABINETS
TOOLS NEEDED FOR INSTALLATION
Drill
1/8” Drill Bit
½” Drill Bit
Philips Head Screwdriver
Level
Square
REQUIRED COMPONENTS
Hardware to mount brackets to the wall (Not Provided
by Elora)
A. Elora Charging Cabinet
B. Wall Mounting Bracket
C. #10 x 1 ¼ Self Tapping Pan Head Screws
D. (4) Toggler Snap toggle BA Heavy Duty 3/16” Toggle
Bolts
E. Recessed Mounting Bezel (for recessed applications
ONLY)
MOUNTING THE CABINET TO WALL
1.
Remove the Elora Charging Cabinet from its packaging
2.
Open the charging cabinet door and locate to the (2)
6-32 x ¼ Pan Head Screws in the top charging bay that
hold on the mounting plate to the rear of the cabinet.
(see figure 1)
3.
Remove these two screws (do NOT discard)
4.
Push down on the mounting plate on the back of the
cabinet. This should allow it to be removed from the
cabinet.
5.
Determine the vertical position at which the top of the
cabinet is to be located. This location should be aligned
with a stud within the wall. Failure to do so could result
in the cabinet becoming dislodged from the wall and
could cause injury and or damage to the unit.
6.
Use the mounting bracket as a template and mark the
locations on the line for the Bolts. Drill pilot holes using
a 1/8” drill bit.
7.
Level and secure the mounting bracket to the wall using
(4) #10 x 1 ¼ Self Tapping Pan Head Screws through
the center holes on the mounting plate.
8.
Reattach the cabinet to the mounting plate using the
(2) 6-32 x ¼ Pan Head screws removed in step 2.
9.
Plug in the cabinet using the 120V power cord supplied
with the unit.
10.
Switch the on/off switch, located on the bottom of the
unit, to the on position.
