118
Appendix Error! Main Document Only.Error! Main Document Only.7 - Error
Messages
M
ONITOR
M
OUSE FOR
DOS E
RROR
M
ESSAGES
This section lists the error messages that can be displayed by MONMOUSE.COM
upon installation, along with a brief explanation where necessary. No error
messages are ever output by an installed copy of MonitorMouse for DOS.
MONMOUSE.COM returns an exit code, sometimes called an "error level" code,
that can allow DOS batch files to process fatal errors with the ERRORLEVEL
command. If the MonitorMouse for DOS command works normally, the returned
code is 0; otherwise it's 1.
Cannot read ELOGRAPH.CAL.
An error occurred while trying to open the file ELOGRAPH.CAL,
possibly due to lack of available file handles or access privileges.
Conflicting TSR.
Another TSR is using the same multiplex interrupt ID value. Try installing
MonitorMouse for DOS with each TSR separately to identify the
contending TSR.
DOS memory deallocation error.
You tried to extract MonitorMouse for DOS, but something has corrupted
your system RAM. Reset your system.
ELODEV not calibrated.
The -c flag was not specified when you loaded ELODEV, or you failed to
run ELOCALIB or DEMOCAL after ELODEV was loaded. See
Chapter 4.
ELODEV not installed.
ELODEV must be installed before loading MonitorMouse for DOS (see
page 44). Look for an error message while the system is booting. If you are
using ELODEV's -i flag, make sure the interrupt is between 60 and 66
(hex), or use MONMOUSE's -i flag.
ELODEV not version x.x or later.
Copy the latest version from your distribution disk into the correct
directory, or contact Elo for the updated version. Check your
AUTOEXEC.BAT file, if any, to see where it looks for ELODEV. To find
out the version, type:
