User Manual: Windows I-Series Interactive Signage
UM600086 Rev A, Page 41 of 45
b. To ensure compliance, use only the provided manufacturers approved line cord.
c. The user is cautioned that changes or modifications to the equipment not expressly
approved by the party responsible for compliance could void the user’s authority to
operate the equipment.
2. If this equipment appears to cause interference with radio or television reception, or any
other device:
a. Verify an emission source by turning the equipment off and on. If you determine that
this equipment is causing the interference, try to correct the interference by using one
or more of the following measures:
I. Move the digital device away from the affected receiver.
II. Reposition (turn) the digital device with respect to the affected receiver.
III. Reorient the affected receiver’s antenna.
IV. Plug the digital device into a different AC outlet so the digital device and the
receiver are on different branch circuits.
V. Disconnect and remove any I/O cables that the digital device does not use.
(Unterminated I/O cables are a potential source of high RF emission levels.)
VI. Plug the digital device into only a grounded outlet receptacle. Do not use AC
adapter plugs. (Removing or cutting the line cord ground may increase RF
emission levels and may also present a lethal shock hazard to the user.)
CE Radiation Exposure Statement:
This equipment complies with CE radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
If you need additional help, consult your dealer, manufacturer, or an experienced radio or
television technician.
III. EC R&TTE Directive
This equipment conforms to all the essential requirements of Directive 1999/5/EC. The
conformity assessment procedure referred to in Article 10 and detailed in Annex [IV] of Directive
1999/5/EC has been with the involvement of the following notified body:
Identification mark: 0700 (Notified body number)
