Elnec 51&AVRprog, User Manual

Page: 93 / 129

Software
93
Note: Characters 0 and 1 immediately changes content of
edit area.
Buffer / Fill block
Selecting this command causes filling selected block of
buffer by requested hex (or ASCII) string. Sets start and
end block for filling and requested hex or ASCII string.
Buffer / Copy block
This command is used to copy specified block of data in
current buffer on new address. Target address needn't be
out from source block addresses.
Buffer / Move block
This command is used to move specified block of data in
current buffer on new address. Target address needn't be
out from source block addresses. Source address block (or
part) will be filled by topical blank character.
Buffer / Swap block
This command swaps a high- and low- order of byte pairs
in current buffer block. This block must started on even
address and must have an even number of bytes. If this
conditions do not fulfil, the program modifies addresses
itself (start address is moved on lower even address and/or
end address is moved on higher odd address).
Buffer / Erase
If this command is selected, the content of the buffer will be
filled with topical blank character.
The reserved key <Ctrl+F2> will bring out this menu from
any menu and any time.
Buffer / Fill random data
If this command is selected, the content of the buffer will be
filled with random data.
The reserved key <Shift+Ctrl+F2> will bring out this menu
from any menu and any time.
Buffer / Checksum
The checksum dialog is used for calculate checksums of
selected block in buffer. The checksums are calculated by
next way :