32
To check:
1 Set the upper feed adjusting dial at “0”.
Attach the dual feed foot.
2. Turn the power switch on and select ( ) stitch.
3. Press the needle up/down button twice to raise the needle,
and the upper feed dog position will be initialized.
4. Press the presser foot lifter button to lower the presser foot.
Turn the power switch off.
5. The clearance between the dual feed foot and upper feed
dog should be 4 mm. If not, follow the procedure below.
To adjust:
1 Remove the top cover (see page 2).
2. Loosen the hexagonal socket screws on upper feed rear
arm (use an Allen wrench of 2 mm width across flats).
3. Insert the 4 mm spacer between the upper feed dog and
dual feed foot to adjust the clearance. Tighten the
hexagonal socket screws.
Dual feed foot
Mechanical Adjustment
Upper feed dog (2)
The clearance between the dual feed foot and upper feed dog should be 4 mm when the stitch length is set at "0".
* Check the upper feed dog (1) (see page 31) before this adjustment.
Upper feed dog
4 mm
Hexagonal socket screws
View from the right upper corner of the machine
Upper feed upper shaft rear arm
Upper feed adjusting dial
Drop feed key
Needle up/down button
Presser foot lifter button
